MultiWAX Wax DIY SET

MultiWAX SET CONTENTS

1 MultiWAX™ All Temp 70g

1 MultiWAX™ Tundra 70g

1 MultiWAX™ Scraper Spatula 20 Cm

1 MultiWAX™ Soft Cork Block

5 MultiWAX™ NC-Tex şeffaf Golgu Çubuğu

1 MultiWAX™ 87 derece çelik Bileme takımı

1 MultiWAX™ Çelik finisaj taşı

5 MultiWAX™ şeffaf DolguWAX

1 Gallium™ P-tex Siyah

1 MultiWAX™ Sticker

MultiWAX™ All Temp is suitable for all skill levels with its special formula that can adapt to all temperatures.

Operating Temperature: 0 / -25 degrees Celsius

Color: Yellow

Application: Hot and Cold

Iron Application: 120 degrees Celsius

COLD APPLICATION: To apply MultiWAX™ All Temp in cold conditions, first remove any existing wax residues using the scraper. Apply MultiWAX™ All Temp parallel to the sliding direction on your snowboard/skis. It will create a sliding layer underneath your equipment. Finally, use the soft foam block to rub the MultiWAX™ All Temp onto the surface to ensure it spreads evenly and adheres properly.

HOT APPLICATION: Always scrape the bottom of your ski/snowboard with a scraper to remove any old wax residues. Use a brush if necessary to continue cleaning. If available, use a wax remover spray for final cleaning. Once the surface is completely clean, heat the MultiWAX™ All Temp from the set with a wax iron set at 120 degrees Celsius and let it melt onto the surface.

Spread the MultiWAX™ All Temp evenly across the entire surface using the iron. Allow it to harden for a while. Use your scraper to scrape off any excess wax. Use the soft foam block for final polishing and to achieve a glossy finish. Clean any wax residues on the edges with the notched edge of your scraper.